Posts with tag "howto"

Avatar

Rewinding a 2205 Brushless Motor

|
+2
Rewinding a 2205 Brushless motor.

Hello everybody!
It’s three years since I’m in the RC hobby, and it was then that I got this kind of motor. It was intended for the well-known Cessna 150. Then it was incorporated into an overseas 4Q, then – into a Vzhik, and now it is installed in a Kesla. Although it has come through snow and water and gave a smoke, it was all right until a few days ago. It was down after I flew my KESL a few times. I guess that is due to winding damage or something like that. Well, that’s not important now.

Avatar

FPV from Scratch in Detail.

|
+2
The whole thing started on a cold and snowy evening. I was having fun after another busy workday at my PC browsing for all sorts of RC hobbyist goodies, as I was about to start building my new plane. When I was well into yet another attempt to comprehend the section describing telemetry equipment, the idea of building a FPV dawned upon me. After a brief consideration, I was fully determined to add my first FPV to my arsenal.

Avatar

An-28. My first twin engine plane

|
+1

Avatar

F-22 The Raptor of Styrofoam Flooring Underlayment

|
+1
Hello! My name is Denis, I’m 13 years old.

Today I will tell you about construction of the model of US fighter F-22, also known as the Raptor. I liked this model due to its appearance, simplicity of construction and low flight speed. After the analysis of drawings and specification I understood that I have all necessary electronics. Well, it’s time to start!

Avatar

Repairing Turnigy AquaStar 3520-1700KV (leak-proofing the cooling system)

|
+1
Leak-proofing the cooling system of Turnigy AquaStar 3520-1700KV

Avatar

"Andreyich", the Trainer

|
+0

Avatar

Glider with an air-droppable motor

|
+0


Now let me show you where my ideas about glider-lifting methods got me…


Avatar

"Yak the fighter aircraft": How to make the Yak-1b in 5 days.

|
+0


I haven't made any new models last winter. I mostly repaired and renewed the old stuff. I also had bad luck breaking one of my little model favorites - "orange" Yak-3. The fault was mine: I hurried and failed while configuring the remote control. Despite the confused controlling I managed to save the plane from a full-force nosedive, but the foam wing spar didn't survive such treatment...
Was there any sense repairing it? It would require a new wing though, besides the replacement traces would be noticable. And where there is a wing, there is everything else...
Such thoughts led me to make a relatively similar but new model.

Avatar

A LiPo pack for a novice...

|
+0


Feedback
/ Register
Your country:
Follow a few simple steps to place an order. Mouse over a picture for details.
Deleted items